If a loudspeaker is clipping, for example, the phenomenon can be aurally understood as distortion or break-up. Physically, if a loudspeaker remains in a clipping state for too long, there is potential for damage to occur due to overheating. However, many speakers have built-in precautions to avoid clipping, such as circuits that act like limiters. Just as when a loudspeaker is pushed beyond its physical limitations, a digital system can be overloaded at the input stage to the point of clipping.
This is because our system has run out of 1s and 0s to accurately convert our signal into digital information.
Any excess data is disregarded, which can result in digital clipping—a sine wave hitting its ceiling and becoming a square wave.
Whereas analogue clipping is more forgiving in the way it chops round waveforms into squares, digital clipping precisely lops the head off our lovely sine wave , resulting in harsh distortion. Probably not as much as it appears. This is, of course, in regards to our channel faders. If the master fader is consistently lighting up red, it can be become a problem for mixing. Clipping sounds like the speakers are just giving up on certain frequencies. To put it simply, clipping happens when you try to push your amplifier too hard.
Clipping is the product of your amplifier trying to deliver too much power to your speakers. To put it less simply, the Sinusoidal Waveform sine wave is supposed to be smooth at the peaks and troughs the tops and bottoms of the wave.
When the gain on an amplifier is increased beyond a level that the speakers can handle, it causes the peaks to spike and become clipped off, causing distortion. It is often but not always the lower frequency range that will trigger clipping, since bass typically requires more power than higher frequencies do.
The image above is a tutorial for correctly setting your gain using a dmm this only works for amplifiers that produce the power that they claim.
To fully eliminate any clipping, you may have to set the gain lower than you would like, and in that case, there are some other things you can try. Seeking out more efficient speakers is another way to get higher volume levels from your amp without requiring as much power. We hate SPAM and promise to keep your email safe. Bio 6x9 Inch Coax Speakers. Strato 6. Meso 6x9 Inch Coax Speakers. Bio 6. The flattened blue lines are the results of the signal being "clipped" off.
It is essential that a live sound engineer set the sound system in a way to avoid clipping because a failure to do so could cause damage to the loudspeakers. When a signal reaches the point of clipping, speaker cones do not move, as the clipped signal is essentially a DC signal for the duration that it exceeds the voltage rail boundaries. This causes all of the power from the amplifier to be used towards heating the voice coils instead of producing sound.
Skip to main content. Mackie Blog. What is Clipping?
0コメント